Product Overview
Finish your heating cable installation with a clean, durable end termination using this End Seal Kit. It uses a two-layer Ø12 heat-shrink sealing method where the inner tube is shrunk until glue flows out for sealing, then a second outer tube is applied with a minimum 1 cm (0.4 in) overlap for added protection. Designed for heating cable end sealing, this kit supports systems up to 240V and 30A, with a maximum continuous exposure temperature of 85°C.
Product Sheets
Key Benefits
- Leak-resistant sealing using adhesive-lined heat shrink (glue flow during shrink).
- Double-layer protection with required overlap for a stronger end seal.
- Field-friendly installation with common tools (cut, shrink, clamp).
Specifications
-
Rated voltage: 240V
-
Max permissible steady-state current: 30A
-
Max continuous exposure temperature: 85°C
-
Note: connection point temperature may exceed 60°C
-
Heat shrink tube sizes referenced in instructions: Ø12 (5cm/2in) and Ø12 (7cm/2.75in)
Installation Summary
-
Trim cable and remove 1 cm (0.4 in) of outer jacket.
-
Remove braiding; slide on Ø12 (5cm/2in) tube.
-
Heat until glue comes out, then clamp the top.
-
Slide on Ø12 (7cm/2.75in) tube and ensure ≥1 cm overlap; repeat heat + clamp.
-
Finish to the shown sealed tip (reference: 3mm–5mm).
